RAE PACESETTER 24V PWM DC DRIVE 100A
On-board adjustments for acceleration/deceleration, reverse speed, throttle gain and throttle center. Anti-rollback circuitry, regenerative braking for safe and quiet operation. Throttle loss, low battery, throttle-out-of-range and throttle sequence protection built-in. Drives an external electromechanical brake up to 2 amps. High power in a small footprint with simple hookup and operation round out this rugged drive.
FEATURES:
- 24 Volt Four-Quadrant Operation provides true regenerative operation for excellent braking and speed control
- Separate Accel/Decel Adjustments provisions for factory set resistors or on-board optional potentiometers
- Anti-Rollback Circuitry minimizes roll back on hills by autosetting the brake delay function
- Current Limit Protection with Peak-Boost Feature rated up to 70 amps peak 25 amps continuous. short-term boost feature for extra power in negotiating obstacles
- Reverse Speed Max adjustment full range adjustment factory set resistor or optional potentiometer
- Input Pot Range Adjustment adjusts input gain to compensate for variations in pot Styles and Rotation – Factory set resistor or optional potentiometer
- Input Pot Center Adjustment allows for easy adjustment of throttle neutral – Standard supplied potentiometer
- Reverse Polarity Protection (Battery Input) prevents closure of the on-board “power” contactor – eliminates voltage blocking devices
- Control Inhibit Input (Logic High) use this input to disable the drive when charging the battery
- High Throttle Monitor prevents operation on start-up until throttle has been returned to a neutral position
- Brake Output provides separate output to a prake (2 amps)
- Pot Loss Protection prevents operation when voltage is less than 16.5-17 vdc. protects motor, controller, and batteries
- Anti-Plug Circuitry prevents instantaneous voltage reversal causing damage to the motor or controller
- Neutral Throttle applies brakes when throttle is released or power is interrupted
- Quick Connect Terminals on all connections to the controller are made through standard 0.250 “fast-on” connectors
